Quick Answer: Why Does My Wood Stain Look Blotchy?

What happens if you stain over stain?

If the stain that you are replacing is darker than the new stain, then yes, you will need to remove the old stain.

If you are going to restain it the same or a darker color, then you don’t need to worry too much as the previous stain won’t be visible once the job is done..

Can you put too much stain on wood?

Any excess stain will redissolve and come off, leaving only the stain that penetrated into the wood. If almost all the stain comes off when you wipe it, the surface probably wasn’t sanded enough. … Allow the wood to dry completely, sand the piece down to bare wood, and apply a coat or two of stain, wiping off any excess.

How do you fix a blotchy stained deck?

You can try to sand away the blotchy area to remove the stain, but your best bet so you can get rid of all the blotchy area is to use a chemical stripper. Brush it on with a paintbrush, and then follow the manufacturer instructions about the duration is needs to sit on the deck to work.

What happens if you don’t wipe off wood stain?

Wood stain is designed to penetrate into the grain of the wood, not to remain on the surface. If you happen to spread it too thickly, or you forget to wipe off excess, the material that remains on the surface will become sticky.

How do you fix too much stain on wood?

Just get a flat pad on a stick with a good sponge or cloth on there, and put some standard mineral spirits in a paint tray. Dip the pad in and rub it on the floor with some pressure to loosen the excess stain. Then take clean, dry, lint-free rags and wipe the excess up.

Does second coat of stain darken wood?

Apply a second coat of stain after the first has dried fully. This will usually produce a darker coloring, but it adds a step to the process and slows production. Substitute a glaze or gel stain for the liquid stain.

Why is my deck stain shiny?

When excess stain (stain that did not soak in) is left on the surface to dry it becomes shiny. This can give the deck an unsightly spotty or blotchy appearance. … To fix it you can lightly wipe your deck with rags and mineral spirits to remove the excess stain that is on top of the wood.

Can I sand off excess stain?

Sand the wood with 100-grit sandpaper by hand using a sanding block. Sand with the wood grain and work until you remove all of the wood stain. You can try to sand just the areas with excess stain, but this method usually results in less than stellar results.

Will mineral spirits remove wood stain?

Oil stain can be modified to some extent if you don’t like the effect. If the wood is too dark, soak a clean cloth in turpentine or mineral spirits and rub the wood firmly and evenly along the grain. This will lighten the stain but not remove it. … Let the completed stain dry for about 24 hours.

How do you fix blotchy wood stain?

If the surface is very blotchy, you’ll have to remove the stain by stripping, sanding, or both, and start over. This time, apply a washcoat of shellac and then the stain. If the blotching isn’t too severe, try using a glaze to soften the contrast between the deeply colored and lighter areas.